C & K Black Push Button Cap for Use with KSA & KSL Series Sealed Tact Switch

Номер на артикул на RS: 787-4833Марка: C & K№ по каталога на производителя: BTN K03 90IMPA: 0
brand-logo

Технически документи

Спецификации

Cap Colour

Black

Accessory Type

Button

Brand

C & K

For Use With

KSA & KSL Series Sealed Tact Switch

Страна на произход

France

Детайли за продукта

Electronic Converter for MR16

Independent converter. IP40, class II double insulation for controlling high-power LEDs.
For controlling 1 to 10 type MR16 LEDs.
Protection with automatic recovery against overheating, open circuits, short circuit on secondary.
Stabilised output: 24 V, 20 W.
Wide range of supply voltage: 100 → 265 Vac.

Low Voltage Lighting Transformers

Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.

Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.

Информацията за складовите наличности временно не е налична.

Моля, проверете отново по-късно.

Информацията за складовите наличности временно не е налична.

€ 0,47

Всеки (ex VAT)

C & K Black Push Button Cap for Use with KSA & KSL Series Sealed Tact Switch

€ 0,47

Всеки (ex VAT)

C & K Black Push Button Cap for Use with KSA & KSL Series Sealed Tact Switch
Информацията за складовите наличности временно не е налична.

Купете в насипно състояние

количествоЕдинична цена
1 - 9€ 0,47
10 - 49€ 0,45
50 - 99€ 0,42
100 - 499€ 0,38
500+€ 0,36

Технически документи

Спецификации

Cap Colour

Black

Accessory Type

Button

Brand

C & K

For Use With

KSA & KSL Series Sealed Tact Switch

Страна на произход

France

Детайли за продукта

Electronic Converter for MR16

Independent converter. IP40, class II double insulation for controlling high-power LEDs.
For controlling 1 to 10 type MR16 LEDs.
Protection with automatic recovery against overheating, open circuits, short circuit on secondary.
Stabilised output: 24 V, 20 W.
Wide range of supply voltage: 100 → 265 Vac.

Low Voltage Lighting Transformers

Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.

Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.