SKF HK 0810 8mm I.D Needle Roller Bearing, 12mm O.D
Технически документи
Спецификации
Brand
SKFInside Diameter
8mm
Outside Diameter
12mm
Roller Bearing Type
Needle
Race Width
10mm
Bore Type
Parallel
Material
Metal
Static Load Rating
4.05kN
Cage Material
Sheet Steel
Number of Rows
1
Dynamic Load Rating
3.69kN
End Type
Open
Reference Speed
19000rpm
Limiting Speed
22000rpm
Maximum Speed - Grease
17000rpm
Maximum Speed - Oil
26000rpm
Fatigue Limit Load
440N
Страна на произход
Slovakia
Детайли за продукта
SKF Drawn Cup Needle Roller Bearings Series HK
SKF Drawn cup needle roller bearings have a deep drawn, thin-walled outer ring with open ends (indicated by the HK prefix).,They are characterised by very low sectional height and high load carrying capacity.
Generally used directly on the shaft, which is hardened and ground. Can also be combined with an inner ring for shaft that is not hardened
Used when the housing bore cannot be used as a raceway for a needle roller cage assembly, but where a very compact and economic bearing arrangement is required
Информацията за складовите наличности временно не е налична.
Моля, проверете отново по-късно.
€ 4,63
Всеки (ex VAT)
1
€ 4,63
Всеки (ex VAT)
1
Купете в насипно състояние
| количество | Единична цена |
|---|---|
| 1 - 4 | € 4,63 |
| 5 - 9 | € 4,46 |
| 10 - 24 | € 4,37 |
| 25+ | € 4,25 |
Технически документи
Спецификации
Brand
SKFInside Diameter
8mm
Outside Diameter
12mm
Roller Bearing Type
Needle
Race Width
10mm
Bore Type
Parallel
Material
Metal
Static Load Rating
4.05kN
Cage Material
Sheet Steel
Number of Rows
1
Dynamic Load Rating
3.69kN
End Type
Open
Reference Speed
19000rpm
Limiting Speed
22000rpm
Maximum Speed - Grease
17000rpm
Maximum Speed - Oil
26000rpm
Fatigue Limit Load
440N
Страна на произход
Slovakia
Детайли за продукта
SKF Drawn Cup Needle Roller Bearings Series HK
SKF Drawn cup needle roller bearings have a deep drawn, thin-walled outer ring with open ends (indicated by the HK prefix).,They are characterised by very low sectional height and high load carrying capacity.
Generally used directly on the shaft, which is hardened and ground. Can also be combined with an inner ring for shaft that is not hardened
Used when the housing bore cannot be used as a raceway for a needle roller cage assembly, but where a very compact and economic bearing arrangement is required