FTDI Chip Cable, Male USB A to Female Unterminated, 0.5m
Технически документи
Спецификации
Brand
FTDI ChipLength
0.5m
Connector 1
USB A
Connector 2
Unterminated
Connector 1 Gender
Male
Connector 2 Gender
Female
Connector B
Unterminated
Connector A Gender
Male
Connector B Gender
Female
Connector A
USB A
Детайли за продукта
USB 2.0 Hi-Speed to MPSSE Cable, FTDI Chip
The USB 2.0 Hi-Speed to MPSSE cables contain a small internal electronic circuit board, utilising the FTDI FT232H, encapsulated into the USB connector end of the cable. This chip handles all the USB signalling and protocols. The cables provide a fast, simple way to connect devices with 3.3 or 5V digital interfaces to USB.
Based on the single chip USB Hi-Speed FT232H device
USB 2.0 Hi-Speed (480Mbits/Second) and Full Speed (12Mbits/Second) compatible
Entire USB protocol handled on the chip – No USB-specific firmware programming required
USB Type A connector for direct connection to a host or hub
USB bus powered
Fully assisted hardware or X-On / X-Off software handshaking
Synchronous Serial (MPSSE) data rates of up to 30Mbps on JTAG, SPI and I²C
1kByte receive and transmit buffers for high data throughput
Transmit and receive LED drive signals
Adjustable receive buffer timeout
Support for USB suspend and resume
Low operating and USB suspend current Low USB bandwidth consumption
UHCI / OHCI / EHCI host controller compatible
Operating temperature range: -40 to +85°C
Cable length: 1800mm
FTDI’s royalty-free D2XX drivers eliminate the requirement for USB driver development in most cases
Информацията за складовите наличности временно не е налична.
Моля, проверете отново по-късно.
€ 39,21
Всеки (ex VAT)
1
€ 39,21
Всеки (ex VAT)
1
Купете в насипно състояние
| количество | Единична цена |
|---|---|
| 1 - 9 | € 39,21 |
| 10 - 19 | € 38,16 |
| 20 - 49 | € 37,15 |
| 50 - 99 | € 36,19 |
| 100+ | € 35,30 |
Технически документи
Спецификации
Brand
FTDI ChipLength
0.5m
Connector 1
USB A
Connector 2
Unterminated
Connector 1 Gender
Male
Connector 2 Gender
Female
Connector B
Unterminated
Connector A Gender
Male
Connector B Gender
Female
Connector A
USB A
Детайли за продукта
USB 2.0 Hi-Speed to MPSSE Cable, FTDI Chip
The USB 2.0 Hi-Speed to MPSSE cables contain a small internal electronic circuit board, utilising the FTDI FT232H, encapsulated into the USB connector end of the cable. This chip handles all the USB signalling and protocols. The cables provide a fast, simple way to connect devices with 3.3 or 5V digital interfaces to USB.
Based on the single chip USB Hi-Speed FT232H device
USB 2.0 Hi-Speed (480Mbits/Second) and Full Speed (12Mbits/Second) compatible
Entire USB protocol handled on the chip – No USB-specific firmware programming required
USB Type A connector for direct connection to a host or hub
USB bus powered
Fully assisted hardware or X-On / X-Off software handshaking
Synchronous Serial (MPSSE) data rates of up to 30Mbps on JTAG, SPI and I²C
1kByte receive and transmit buffers for high data throughput
Transmit and receive LED drive signals
Adjustable receive buffer timeout
Support for USB suspend and resume
Low operating and USB suspend current Low USB bandwidth consumption
UHCI / OHCI / EHCI host controller compatible
Operating temperature range: -40 to +85°C
Cable length: 1800mm
FTDI’s royalty-free D2XX drivers eliminate the requirement for USB driver development in most cases