SKF HK 5020 50mm I.D Needle Needle Roller Bearing, 58mm O.D
Технически документи
Спецификации
Brand
SKFInside Diameter
50mm
Outside Diameter
58mm
Roller Bearing Type
Needle
Race Width
20mm
Bore Type
Parallel
Material
Metal
Static Load Rating
63kN
Cage Material
Sheet Steel
Number of Rows
1
Dynamic Load Rating
29.2kN
End Type
Open
Limiting Speed
5600rpm
Reference Speed
5000rpm
Maximum Speed - Oil
5600rpm
Maximum Speed - Grease
4000rpm
Fatigue Limit Load
7.8kN
Страна на произход
Germany
Детайли за продукта
SKF Drawn Cup Needle Roller Bearings Series HK
SKF Drawn cup needle roller bearings have a deep drawn, thin-walled outer ring with open ends (indicated by the HK prefix).,They are characterised by very low sectional height and high load carrying capacity.
Generally used directly on the shaft, which is hardened and ground. Can also be combined with an inner ring for shaft that is not hardened
Used when the housing bore cannot be used as a raceway for a needle roller cage assembly, but where a very compact and economic bearing arrangement is required
€ 17,46
€ 17,46 Всеки (ex VAT)
1
€ 17,46
€ 17,46 Всеки (ex VAT)
1
Информацията за складовите наличности временно не е налична.
Моля, проверете отново по-късно.
| количество | Единична цена |
|---|---|
| 1 - 4 | € 17,46 |
| 5 - 9 | € 16,75 |
| 10 - 24 | € 16,44 |
| 25+ | € 16,08 |
Технически документи
Спецификации
Brand
SKFInside Diameter
50mm
Outside Diameter
58mm
Roller Bearing Type
Needle
Race Width
20mm
Bore Type
Parallel
Material
Metal
Static Load Rating
63kN
Cage Material
Sheet Steel
Number of Rows
1
Dynamic Load Rating
29.2kN
End Type
Open
Limiting Speed
5600rpm
Reference Speed
5000rpm
Maximum Speed - Oil
5600rpm
Maximum Speed - Grease
4000rpm
Fatigue Limit Load
7.8kN
Страна на произход
Germany
Детайли за продукта
SKF Drawn Cup Needle Roller Bearings Series HK
SKF Drawn cup needle roller bearings have a deep drawn, thin-walled outer ring with open ends (indicated by the HK prefix).,They are characterised by very low sectional height and high load carrying capacity.
Generally used directly on the shaft, which is hardened and ground. Can also be combined with an inner ring for shaft that is not hardened
Used when the housing bore cannot be used as a raceway for a needle roller cage assembly, but where a very compact and economic bearing arrangement is required