Texas Instruments SN75116N, LVDS Transceiver, 16-Pin PDIP
Технически документи
Спецификации
Maximum Operating Temperature
+70 °C
Minimum Operating Temperature
0 °C
Pin Count
16
Mounting Type
Through Hole
Manufacturer Part No.
82-6552.1000
Width
6.35mm
Height
4.57mm
Length
19.3mm
Package Type
PDIP
Brand
Texas InstrumentsDimensions
19.3 x 6.35 x 4.57mm
Детайли за продукта
Flying leads adaptor for USB-II Platform Cable, Xilinx
The adaptor makes possible to use flying wires for connections to distributed terminals on a target system.
The adaptor is a small circuit board with two connectors.
The connector on the bottom side of the adapter mates with the 14-pin Platform Cable USB II male 2-mm connector. A 7-pin right-angle header on the top side of the adapter mates with the standard Xilinx flying wire set.
Flying Leads : Provide pins on your printed circuit board for your desired configuration mode. For example, Boundary-Scan configuration would require VCC, GND, TCK, TDO, TDI and TMS header pins. Each lead is labeled to identify the proper pin connection.
Programmable Logic Programming
Информацията за складовите наличности временно не е налична.
Моля, проверете отново по-късно.
P.O.A.
Стандарт
5
P.O.A.
Стандарт
5
Технически документи
Спецификации
Maximum Operating Temperature
+70 °C
Minimum Operating Temperature
0 °C
Pin Count
16
Mounting Type
Through Hole
Manufacturer Part No.
82-6552.1000
Width
6.35mm
Height
4.57mm
Length
19.3mm
Package Type
PDIP
Brand
Texas InstrumentsDimensions
19.3 x 6.35 x 4.57mm
Детайли за продукта
Flying leads adaptor for USB-II Platform Cable, Xilinx
The adaptor makes possible to use flying wires for connections to distributed terminals on a target system.
The adaptor is a small circuit board with two connectors.
The connector on the bottom side of the adapter mates with the 14-pin Platform Cable USB II male 2-mm connector. A 7-pin right-angle header on the top side of the adapter mates with the standard Xilinx flying wire set.
Flying Leads : Provide pins on your printed circuit board for your desired configuration mode. For example, Boundary-Scan configuration would require VCC, GND, TCK, TDO, TDI and TMS header pins. Each lead is labeled to identify the proper pin connection.